2 Ply Non Reflective Window Film:
Visible Light Reflected
Ø Key Features:
Durable dual-ply construction
Non-reflective (no metal)
No signal interference with satellite radio, GPS, cellular and tire pressure monitoring systems
99% UV protection
Available in four shades
3 years limited warranty
dual-ply construction combines the high heat rejection characteristics of aluminum for optimum performance.
This helps to not only increase the heat rejection properties of the film, but also helps to extend the life of the
vehicles interior by minimizing fading.
Ø Unique Advantage:
1,Control more than 99% harmful UV rays, Isolate 90% of heat source, IR fom sun;
2,Isolate 99% of UV rays that cause fading the trims and interior car accessories;
3,High Transparency by 73% allowing light to pass through;
4,Prevent glare from the sun, which given a sense of comfort while driving;
5,Three Brand for you to choose: Carty-series, MG-series, and Van Gogh-series;
Technology : Metal Coating (hard coating) Processing;Raw Material: Optical PET as raw mateial;
Ø Physical Data:
Visible Light Transmission:
Visible Light Reflection:
1.5mil, 2mil, 4mil, 8mil
50cm, 75cm, 90cm, 100cm, 1.52m
1m, 3m, 6m, 12m, 30m, 60m
Big roll: each one with single box packing;
small roll: each one with cubic box, then 50-120 rolls in one carton.
1. Clean the glass thoroughly with detergent and water .leave no spots or dirty on it .
2. Cut your Solar Film (catch release film )to the shape of and larger size than the glass (each side extruding some or 1/4)
3. At one corner of your solar film ,apply a small piece of adhesive tape to each side ,pulling apart ,your solar film
can be easily separated from the release film .Spray water to the adhesive side of your tint solar film whilst the film
are being separated.
4. Squeeze out the water in between your solar film and the glass with squeegee.